AbstractBroadband packet networks based on asynchronous transfer mode (ATM) are expected to provide a wide range of services, including motion video, voice, data and image. When these networks become prevalent, some applications such as motion video and high‐speed LAN interconnections will place a very large bit rate requirement on the channels. Currently, the physical layer supported by the synchronous optical network (SONET) allows the transmission of up to 2.4 Gbit/s with the OC‐48 optical interface. However, it is not feasible for the electronic packet switch to route packets at this rate on a single link. In this paper we present a design of a broadband packet switch that uses multiple links in parallel to realize a high‐speed channel. This implementation permits the switch to operate at the lower link rate, which can be at 150 Mbit/s, while having the ability to support a virtual circuit at a higher rate (up to 2.4 Gbit/s). The main contribution of the design is that packet sequence on a channel is still maintained even though packets are allowed to use any of the links belonging to the same channel. Besides allowing the switch to function at a slower rate than the transmission channel rate, the implementation of the multilinks benefits from statistical multiplexing gain. Analytical results show the performance advantages of multilink design with respect to delay, throughput and packet loss probab