An examination of the results of the accuracy measurements of a bench top audio‐frequency selective voltmeter, based on the superheterodyne principle, showed that an accuracy of the order of only 10% of measured values could be achieved if no internal error correction procedure in the measurements had been used. The temperature variations of the parameters of the quartz band‐pass filter have been identified as the main source of the measurement error. An application of the internal reference signal from a relatively simple and inexpensive source improved the overall accuracy up to the order of 3%. Finally, it was shown that by combining the wide band and selective measurements of the signals from the built‐in tracking generator further improved the overall accuracy to better than 1% and eliminated altogether the need for using any separate source of internal reference signals.