A low-frequency directional flextensional transducer and line array
作者:
Stephen C. Butler,
John L. Butler,
Alexander L. Butler,
George H. Cavanagh,
期刊:
The Journal of the Acoustical Society of America
(AIP Available online 1997)
卷期:
Volume 102,
issue 1
页码: 308-314
ISSN:0001-4966
年代: 1997
DOI:10.1121/1.419609
出版商: Acoustical Society of America
关键词: TRANSDUCERS;PIEZOELECTRICITY;CERAMICS;UNDERWATER;RADIATION PRESSURE;SOUND WAVES;ACOUSTIC MEASUREMENTS
数据来源: AIP
摘要:
A unique low-frequency (900 Hz) class IV flextensional transducer that produces an enhanced far-field pressure on one side and canceled far-field pressure on the other side has been developed. The transducer radiating surface consists of a thick-walled elliptical aluminum shell and a U.S. Navy type III piezoelectric stack along its major axis with two active sections and one inactive section. The directionality is achieved by simultaneously exciting the shell into an omnidirectional and dipole operation by driving stack into both extensional and bending modes. Both measurements and modeling on this device show a front to back pressure ratio of more than 30 dB, producing cardioid-type radiation patterns over an octave band, for a single transducer element. The transducers measured mechanicalQis 8, coupling coefficient is 0.25, and electroacoustic efficiency is 80% and produced a source level of 215 dBre:1μPaat 1 m when driven at a field limit of 394 kV/m (10 kV/in.) at resonance. The uniqueness of this transducer is its directional beam patterns (directivity index=3.4 dB) and high acoustic output power from a small (less than a third of a wavelength) single element. Six of these transducers were placed in a closely packed line array two-wavelengths long. The array successfully produced narrow directional sound beams (directivity index=8.7 dB) with a front to back ratio greater than 30 dB and a source level of 225 dBre:1μPaat 1 m.
点击下载:
PDF
(237KB)
返 回