AbstractThis paper describes the NRD guide (nonradiative dielectric waveguide) proposed as a new type of dielectric transmission line for millimeter‐wave integrated circuits. After the operation principle and the modes of the NRD guide are explained briefly, the nonradiative and low‐loss nature of practical importance are confirmed experimentally. Next, the behavior of the transmitted wave in a bend is studied. Configurations and characteristics of typical NRD guide circuit elements, such as a matched terminator, a directional coupler, a circulator, a beam lead diode mount and a Gunn diode oscillator also are discussed. Using these circuit elements, a transmitter and a receiver are fabricated at 35 GHz and their performances are evaluated. The dimensions of the transmitter and the receiver are as compact as 68 mm × 66 mm and 85 mm × 75 mm in area, respectively. The output power of the transmitter is 10 mW and the temperature coefficient of the frequency is 0.57 ppm/°C. The temperature coefficient of the receiver also is as small as −0.76 ppm/°C. The noise figure is measured to be 10.6 dB. This value is obtained by using Si diodes in the mixer. Finally, as particular applications of the NRD guide, a filter, a power divider, and a leaky‐wave antenna ar