An experimental study of ceramic lubrication by tribopolymerization at high loads and high speeds, using a pin-on-disk (fixed ball-on-flat) machine with alumina-on-alumina, is presented. In order to extend the range of applied loads and sliding velocities beyond those used in previous studies, a three-factor, two-level designed experiment was carried out to determine the effects of monomer structure, load, and speed on wear. Five monomers of widely varying chemical structure were used at one percent concentration in a hydrocarbon carrier fluid, hexadecane. They consisted of (a) one condensation-type monomer, a partial glycol ester of a longchain dimer acid, and (b) four vinyl-type addition monomers. Two levels of load (40 and 160 N) and speed (0.25 and 1.0 m/s) - each varying by a factor of four were used; thus the range of frictional heat generation was 16 to 1.