The creep rapture behaviour of 2.25Cr—1Mo steel in air and in a salt mixture was studied. The salt coating, which can form a liquid phase at the test temperatures, increased the creep rate and reduced the rupture life of the material. The coating reduced the available cross-section of the material by removing the surface layers, thereby resulting in a reduction of the rupture life. Cross-sections of coated samples showed an outer oxide layer comprising oxide of the metal and precipitates of sulphide at the metal/oxide interface. This subsurface penetration of the corrodants was responsible for the early failure of the coated samples. This is typical of hot corrosion mechanisms. The formation of various carbides like M23C6and M6C, as observed by transmission electron microscopy, during creep reduced the creep strength of the material both in air and in the coated state. Increasing temperature enhanced the formation of these carbides with a consequent decrease in creep strength. Applied stress did not seem to play much of a role in the degree of carbide precipitation.