首页   按字顺浏览 期刊浏览 卷期浏览 Effect of preheat treatment on ingot structure and recrystallisation of brass component...
Effect of preheat treatment on ingot structure and recrystallisation of brass component of rolling texture in hot rolled AA 5182

 

作者: HollinsheadP. A.,  

 

期刊: Materials Science and Technology  (Taylor Available online 1992)
卷期: Volume 8, issue 1  

页码: 56-62

 

ISSN:0267-0836

 

年代: 1992

 

DOI:10.1179/026708392790169795

 

出版商: Taylor&Francis

 

数据来源: Taylor

 

摘要:

AbstractTwo different preheating treatments were used to vary the Al6Mn dispersoid characteristics in AA 5182. High temperature followed by slow cooling produced coarse, needlelike dispersoids which allowed rapid recrystallisation following hot rolling, whereas a low temperature preheat produced afine dispersion of low aspect ratio particles which retarded recrystallisation. Long, unrecrystallised bands persisted in the hot rolled material subected to the low temperature preheat even after holding for 24 h at the final pass temperature. Micro-orientation determinations within the bands showed that they were predominantly of the brass (Bs) orientation, {110}〈112〉, confirming the results of X-ray bulk texture analyses. The results are considered conclusive evidence of the widely reported higher resistance to recrystallisation of the Bs orientation compared with other orientations in rolled high stacking fault energy fcc metals. The Bs oriented bands could be removed by annealing at a temperature substantially greater than that experienced in the final hot rolling pass.MST/1475

 

点击下载:  PDF (3207KB)



返 回