Adhesive bonding of dental luting cements; influence of surface treatment
作者:
ØiloGudbrand,
期刊:
Acta Odontologica Scandinavica
(Taylor Available online 1978)
卷期:
Volume 36,
issue 5-6
页码: 263-270
ISSN:0001-6357
年代: 1978
DOI:10.3109/00016357809029076
出版商: Taylor&Francis
关键词: Dental materials;dentin;acid etch;scanning electron microscopy
数据来源: Taylor
摘要:
Øilo, G. Adhesive bonding of dental luting cements; influence of surface treatment.Tensile bond strength of four different luting cements to smooth dentin surfaces was measured. A chisel edged, stainless steel ring was cemented to the butt end of a dentin cylinder. The dentin was polished to a plane and smooth surface before cementation. The cements were also applied to dentin surfaces that were treated with a pumice slurry, etched with different acid solutions, or covered with different liners.The results showed that the polycarboxylate cement had a tensile bond strength to smooth, untreated dentin of approximately 4 MN/m3. The zinc phosphate and EBA cements had a bond strength of 0, 6 MN/m2and the composite resin cement had no measurable bond to untreated dentin.All dentin treatments showed in general a decreasing effect on the bond strength of zinc phosphate, polycarboxylate and EBA cements, whereas that of composite resin cement showed a slight increase.
点击下载:
PDF (1808KB)
返 回