ISSN:0039-2103    

DOI:10.1111/j.1475-1305.1970.tb01680.x

出版商:Blackwell Publishing Ltd    

年代:1970

数据来源: WILEY

摘要:

The Editor is worried that readers of Strain may find some of the articles rather difficult to understand, and he believes that a considerable part of the difficulties lies in the specific scientific language that authors adopt in their quest for a precision the need of which is not always obvious to the average reader. As a help to readers, therefore, the following “Technical Glossary” is re‐published

ISSN:0039-2103    

DOI:10.1111/j.1475-1305.1970.tb01681.x

出版商:Blackwell Publishing Ltd    

年代:1970

数据来源: WILEY

摘要:

Strain gauges measure directly strains in models and marine components and are parts of torque and thrust transducers and of force and moment balances. Six‐component balances of strut and shear‐plate design and special sliprings are descri

ISSN:0039-2103    

DOI:10.1111/j.1475-1305.1970.tb01682.x

出版商:Blackwell Publishing Ltd    

年代:1970

数据来源: WILEY

摘要:

A simplified theory for the prediction of points of zero strain in dynamometer rings under diametral loads has been verified by experiment and found to give very good results. These points can be used for the separation by strain gauge indications of the effects of two mutually perpendicular forces.

ISSN:0039-2103    

DOI:10.1111/j.1475-1305.1970.tb01683.x

出版商:Blackwell Publishing Ltd    

年代:1970

数据来源: WILEY

摘要:

Strain gauge bridges and thermocouples on a waisted section of the shaft, with heated potted amplifiers rotating with the shaft, measure changes in preload due to bearing temperature changes in an experimental simplified mainspindle assembly.

ISSN:0039-2103    

DOI:10.1111/j.1475-1305.1970.tb01684.x

出版商:Blackwell Publishing Ltd    

年代:1970

数据来源: WILEY

摘要:

An approximate rapid method is described for calculating in the moiré technique the transversal strain directly from the longitudinal strain distribution across sections of symmetry. The method is based on evaluation of the load transmitted through the section and is corroborated by two examples

ISSN:0039-2103    

DOI:10.1111/j.1475-1305.1970.tb01685.x

出版商:Blackwell Publishing Ltd    

年代:1970

数据来源: WILEY

摘要:

Axial compression of thin circular discs made of plasticized epoxy resin was studied. The plane faces were cemented to platens rigid compared with the material of the discs so that the constraint due to cementing created in the discs a three‐dimensional state of stress. The internal strain distribution was measured by the moiré method which yielded enough data for an evaluation of this state of stress. The influence of the aspect‐ratio of diameter D to thickness t of the disc was investig

ISSN:0039-2103    

DOI:10.1111/j.1475-1305.1970.tb01686.x

出版商:Blackwell Publishing Ltd    

年代:1970

数据来源: WILEY

摘要:

A simple compensator for photoelastic work not requiring partial fringe determination may be made from urethane rubber (1) which is extremely sensitive to the photoelastic effect.

ISSN:0039-2103    

DOI:10.1111/j.1475-1305.1970.tb01687.x

出版商:Blackwell Publishing Ltd    

年代:1970

数据来源: WILEY

摘要:

The principles of stress separation, by the classical and by Tésar's methods, from observations on slices of frozen‐stress photoelastic models are explained with illustrations for axisymmetric and general three‐dimensional problems and for problems with a plane of symm

ISSN:0039-2103    

DOI:10.1111/j.1475-1305.1970.tb01688.x

出版商:Blackwell Publishing Ltd    

年代:1970

数据来源: WILEY

ISSN:0039-2103    

DOI:10.1111/j.1475-1305.1970.tb01689.x

出版商:Blackwell Publishing Ltd    

年代:1970

数据来源: WILEY