1. |
Aktuelles |
|
Chemie Ingenieur Technik,
Volume 65,
Issue 6,
1993,
Page 601-676
Preview
|
PDF (32078KB)
|
|
ISSN:0009-286X
DOI:10.1002/cite.330650602
出版商:WILEY‐VCH Verlag
年代:1993
数据来源: WILEY
|
2. |
Druckschwingungen durch oszillierende Verdrängerpumpen in Rohrleitungssystemen |
|
Chemie Ingenieur Technik,
Volume 65,
Issue 6,
1993,
Page 677-692
Gerhard Vetter,
Bernd Seidl,
Preview
|
PDF (1420KB)
|
|
摘要:
AbstractPressure Pulsations Caused by Reciprocating Pumps in Piping Systems. The safe design of piping installations for reciprocating pumps requires proper knowledge about the pump/installation interaction. In many cases critical resonance effects can be avoided by proper piping geometry or improved pump performance with respect to the volumetric efficiency (primary measures). Normally it is necessary to use various secondary dampening methods which can influence the acoustics of the piping system. Several examples of experimental computer simulations of damper action – upstream and downstream – are presented for fluidand gas‐filled damper versions. The influence of entry geometry of the dampers is explained, hints on the proper geometry of the entries are given and the effects of various dampers and their influence on the total acoustics are discussed. Special reference is made to the effect of orifices as dissipative and acoustic elements in piping systems. The investigation shows the importance of analyzing of the total system of pump, piping installation and vessels or reactors and the application of computer simulation for piping d
ISSN:0009-286X
DOI:10.1002/cite.330650603
出版商:WILEY‐VCH Verlag
年代:1993
数据来源: WILEY
|
3. |
Werkstoffauswahl in der Chemischen Verfahrenstechnik |
|
Chemie Ingenieur Technik,
Volume 65,
Issue 6,
1993,
Page 693-702
Ubbo Gramberg,
Preview
|
PDF (1046KB)
|
|
摘要:
AbstractChoice of Materials of Construction for Chemical Process Engineering. The choice of appropriate materials is of critical importance for the trouble‐free operation of chemical plant and for economic production. Questions of materials should therefore be considered at an early stage of process development. As a rule, the boundary conditions having a direct influence on the choice of materials are communicated by the process engineer to the materials scientist. Several approaches to the proper choice of materials are usually possible. This choice must ensure that adequate safety reserves are available without making the plant unnecessarily expensive. Although numerous methods are available for determining the properties of materials, testing under operating conditions for specific applications is the optimal approach. The experience amassed by materials experts in practice is an extremely important and indispensable factor because there is much knowledge which cannot simply be expressed in equations and number
ISSN:0009-286X
DOI:10.1002/cite.330650604
出版商:WILEY‐VCH Verlag
年代:1993
数据来源: WILEY
|
4. |
Rohstoff‐Recycling und Energie‐Gewinnung von Kunststoffabfällen |
|
Chemie Ingenieur Technik,
Volume 65,
Issue 6,
1993,
Page 703-709
Thomas Geiger,
Hans Knopf,
Gerhard Leistner,
Rainer Römer,
Helmut Seifert,
Preview
|
PDF (1004KB)
|
|
摘要:
AbstractFeedstock Recycling and Energy Recovery from Plastics Waste. The disposal concept of the plastics industry comprises the following four steps: prevention/reduction, recycling of material (mechanical recycling, feedstock recycling), energy recovery and dumping. Feedstock recycling or chemical recycling stands for the chemical conversion of polymer materials with reduction of macromolecular structure to low‐molecular raw materials. The combustion of plastics waste uses the high calorific value of plastics for energy recovery. This paper describes some of the processes for feedstock recycling and for energy recovery from plastics wast
ISSN:0009-286X
DOI:10.1002/cite.330650605
出版商:WILEY‐VCH Verlag
年代:1993
数据来源: WILEY
|
5. |
Verhalten feinkörniger Schüttgüter |
|
Chemie Ingenieur Technik,
Volume 65,
Issue 6,
1993,
Page 710-718
Otto Molerus,
Preview
|
PDF (858KB)
|
|
摘要:
AbstractBehaviour of Fine‐Grained Bulk Solids. The behaviour of fine‐grained bulk solids embraces such diverse phenomena as the moistening properties or thermal conductivity. Only two aspects are considered in this article, viz, the mechanics of bulk materials and the flow mechanics of fine‐grained bulk solids. The interplay of these two areas is illustrated by a detailed analysis of the various kinds of gas fluidis
ISSN:0009-286X
DOI:10.1002/cite.330650606
出版商:WILEY‐VCH Verlag
年代:1993
数据来源: WILEY
|
6. |
Energetische Beurteilung des Stoffaustausches im Multiwir‐Wäscher |
|
Chemie Ingenieur Technik,
Volume 65,
Issue 6,
1993,
Page 719-720
Marian Krotki,
Eckhart Blaß,
Preview
|
PDF (406KB)
|
|
ISSN:0009-286X
DOI:10.1002/cite.330650607
出版商:WILEY‐VCH Verlag
年代:1993
数据来源: WILEY
|
7. |
Abzugskräfte und Abzugsverhalten – Untersuchungen am Gurtförderer |
|
Chemie Ingenieur Technik,
Volume 65,
Issue 6,
1993,
Page 721-723
Dietmar Schulze,
Jörg Schwedes,
Preview
|
PDF (342KB)
|
|
ISSN:0009-286X
DOI:10.1002/cite.330650608
出版商:WILEY‐VCH Verlag
年代:1993
数据来源: WILEY
|
8. |
Drehtrommel mit axialer Einspeisung von Schüttgut |
|
Chemie Ingenieur Technik,
Volume 65,
Issue 6,
1993,
Page 723-724
Rolf Körber,
Paul Schmidt,
Preview
|
PDF (239KB)
|
|
ISSN:0009-286X
DOI:10.1002/cite.330650609
出版商:WILEY‐VCH Verlag
年代:1993
数据来源: WILEY
|
9. |
Diskontinuierliches Vermischen von Flüssigkeitsstrahlen in zylindrischen Behältern |
|
Chemie Ingenieur Technik,
Volume 65,
Issue 6,
1993,
Page 725-726
Rudolf Renz,
Henning Bode,
Dieter Mewes,
Preview
|
PDF (339KB)
|
|
ISSN:0009-286X
DOI:10.1002/cite.330650610
出版商:WILEY‐VCH Verlag
年代:1993
数据来源: WILEY
|
10. |
Stoffaustausch in einem adiabaten Wabenrohrreaktor |
|
Chemie Ingenieur Technik,
Volume 65,
Issue 6,
1993,
Page 727-728
Rudolf Heinisch,
Andreas Rogowski,
Ehrenfried Schütt,
Preview
|
PDF (240KB)
|
|
ISSN:0009-286X
DOI:10.1002/cite.330650611
出版商:WILEY‐VCH Verlag
年代:1993
数据来源: WILEY
|