1. |
The initiation of vinyl polymerization by a model peroxy ester |
|
Die Makromolekulare Chemie,
Volume 47,
Issue 1,
1961,
Page 1-6
C. P. J. Glaudemans,
Preview
|
PDF (253KB)
|
|
摘要:
AbstractThe fully acetylated di‐peroxy ester of mucic acid was used to initiate the polymerization of styrene, and 84% of the theoretical amount of CO2was collected. Treatment with base did not affect the intrinsic viscosity of the resulting polymer. When this saponified polymer was subsequently oxidized by lead tetraacetate, its intrinsic viscosity showed a decrease. It is concluded that the peroxy ester showed a concerted split of the OO and CC bonds during the initiation and that the alkoxy counter‐radical is quite inactive towards polymer
ISSN:0025-116X
DOI:10.1002/macp.1961.020470101
出版商:Hüthig&Wepf Verlag
年代:1961
数据来源: WILEY
|
2. |
Block polymerizations with trapped radicals |
|
Die Makromolekulare Chemie,
Volume 47,
Issue 1,
1961,
Page 7-14
J. Hiemeleers,
G. Smets,
Preview
|
PDF (363KB)
|
|
摘要:
AbstractPolymers prepared in heterogeneous medium can be used for the synthesis of block polymers, if they contain trapped radicals. With polyacrylonitrile the molar content of second monomer (vinyl acetate, vinylidene chloride, styrene, acrylamide) is low and inferior to 5%, except with methyl methacrylate (9%), acrylic acid (16%), methyl acrylate (14,3%) and acrylonitrile itself (∼36%). In this last case, the addition of monomer causes an appreciable increase of the highest molecular fraction.With polyacrylamide the incorporation of second monomer is low and exceeds not 8 mole % with acrylonitrile and acrylic acid. Finally in the case of polyvinyl chloride no block polymerization could be detected.The block polymers described in this paper have been purified from the homopolymers by selective extraction or by fractionated precipitatio
ISSN:0025-116X
DOI:10.1002/macp.1961.020470102
出版商:Hüthig&Wepf Verlag
年代:1961
数据来源: WILEY
|
3. |
Polymerization with redox initiators. V. Substituent effects in the initiator system diethylaniline‐benzoyl peroxide |
|
Die Makromolekulare Chemie,
Volume 47,
Issue 1,
1961,
Page 15-18
K. F. O'Driscoll,
E. N. Ricchezza,
Preview
|
PDF (169KB)
|
|
摘要:
AbstractThe kinetics of the polymerization of styrene initiated by the system benzoyl peroxide — substituted diethylaniline has been studied at 30°C. The rate constant for the induced decomposition of the peroxide is found to depend on the amine basicity and is correlated with the HAMMETσ. The efficiency of the system is found to be enhanced by the presence of electron withdrawing substituents on the anil
ISSN:0025-116X
DOI:10.1002/macp.1961.020470103
出版商:Hüthig&Wepf Verlag
年代:1961
数据来源: WILEY
|
4. |
Rate constant of propagation reaction in stationary state of cationic polymerization. Part I. A tentative method for determination of rate constant of propagation reaction. (polymerization ofp‐methoxystyrene catalyzed by iodine) |
|
Die Makromolekulare Chemie,
Volume 47,
Issue 1,
1961,
Page 19-34
S. Okamura,
N. Kanoh,
T. Higashimura,
Preview
|
PDF (528KB)
|
|
摘要:
AbstractA tentative method for the determination of the rate constant of the propagation reaction (kp) in the stationary state of cationic polymerization was proposed, and as an example of its application, kpvalues ofp‐methoxystyrene initiated by iodine were obtained in ethylene chloride and in carbon tetrachloride. It was found that kpvalue increased remarkably as the dielectric constant of the polymerizing solution increased. The proprieties of the suppositions upon which the method applied here depended were examined and proved to be reasonabl
ISSN:0025-116X
DOI:10.1002/macp.1961.020470104
出版商:Hüthig&Wepf Verlag
年代:1961
数据来源: WILEY
|
5. |
Rate constant of propagation reaction in stationary state of cationic polymerization. Part II. Rate constant of the propagation reaction of alkyl vinyl ethers‐iodine systems |
|
Die Makromolekulare Chemie,
Volume 47,
Issue 1,
1961,
Page 35-47
S. Okamura,
N. Kanoh,
T. Higashimura,
Preview
|
PDF (433KB)
|
|
摘要:
AbstractRate constants of the propagation reaction (kp) of isobutyl vinyl ether and 2‐chloroethyl vinyl ether initiated by iodine were obtained in ethylene chloride and inn‐hexane by the method proposed in the proceeding paper. Also in these systems, it was noticed that kpvalue increased as the dielectric constant of the polymerization system increased. kpvalues of these two monomers mentioned above were compared with their monomer reactivity ratio and it was proved that the numerical values which we obtained coincided well with each other. Thus, the method of determination of kpapplied here must have been reasona
ISSN:0025-116X
DOI:10.1002/macp.1961.020470105
出版商:Hüthig&Wepf Verlag
年代:1961
数据来源: WILEY
|
6. |
Über natürliche und synthetische amylose. XV. Umsetzung von amylose und cellulose mit essigesterisocyanat |
|
Die Makromolekulare Chemie,
Volume 47,
Issue 1,
1961,
Page 48-71
Von E. Husemann,
R. Resz,
R. Werner,
Preview
|
PDF (1154KB)
|
|
摘要:
AbstractAmylose und Cellulose wurden mit Essigesterisocyanat zu Tri‐carbäthoxymethylcarbamaten, die gute Löslichkeitseigenschaften besitzen, umgesetzt. Bei Amylose‐tricarbäthoxymethylcarbamaten lautet die Viskositäts‐Molekulargewichts‐Beziehung in Acetonlösung:\documentclass{article}\pagestyle{empty}\begin{document}$ [{\rm \eta ] = \hbox{1,02}} \cdot {\rm P}^{{\rm 0,63}}.$\end{document}Die Substanzen lassen sich gut quantitativ fraktionieren.Durch partielle Verseifung wurden die Amylosecarbamate in wasserlösliche Salze und durch Einwirkung von Ammoniak bzw. Hydrazin in Säureamide und Säurehydrazide übergeführt.Durch Umsetzung von partiell acetylierten Amylosen mit Essigesterisocyanat und anschließende Verseifung der Acetylgruppen erhält man ein wasserlösliches Negativ der ursprünglichen Substituentenverteilung, die sich nun durch Perjodatoxydation bestimmen läßt.Hydrophobe Derivate der Amylose und Cellulose, z. B. Jodderivate, können durch Einführung weniger Carboxymethylcarbamatgruppen was
ISSN:0025-116X
DOI:10.1002/macp.1961.020470106
出版商:Hüthig&Wepf Verlag
年代:1961
数据来源: WILEY
|
7. |
Dynamisch‐mechanische eigenschaften von polyurethan. 2. Mitt. Der einfluß von quellungsmitteln auf das mechanische verhalten von polyurethan |
|
Die Makromolekulare Chemie,
Volume 47,
Issue 1,
1961,
Page 72-85
Von Herbert Jacobs,
Ernst Jenckel,
Preview
|
PDF (554KB)
|
|
摘要:
AbstractDer Einfluß verschiedenartiger niedrigmolekularer Quellungsmittel auf die mechanischen Eigenschaften von Polyurethan wurde in einem Temperaturbereich von −180°C bis etwa 50°C oberhalb der Glastemperatur mit Hilfe von freien Torsionsschwingungen bei konstanter Frequenz von 1 Hz untersucht.Während man bei ungequollenem Material nur zwei Relaxationsgebiete beobachtet (α‐Maximum bei etwa +40°C und α‐Maximum bei etwa −135°C), erscheint bei Quellungsmittelzusatz ein drittes Relaxationsgebiet bei etwa −70°C (β‐Maximum).Die Temperaturlage des α‐Maximums verschiebt sich mit steigender Konzentration an Quellungsmittel zu tieferen Temperaturen. (Das ist gleichbedeutend mit einer Erniedrigung der Glastemperatur.) Diese Erniedrigung ist bei allen untersuchten Systemen – mit Ausnahme des Systems Polyurethan/Wasser – dieselbe, wenn man die Konzentration des Quellungsmittels im Grundmolenbruch angibt. Auf Grund dieser Meßergebnisse werden Rückschlüsse auf die Art der Bindung der Quellungsmitt
ISSN:0025-116X
DOI:10.1002/macp.1961.020470107
出版商:Hüthig&Wepf Verlag
年代:1961
数据来源: WILEY
|
8. |
Kinetik der „polymerisation”︁ von isopren und styrol mit n‐butyllithium als katalysator. II |
|
Die Makromolekulare Chemie,
Volume 47,
Issue 1,
1961,
Page 86-89
Von Hansjörg Sinn,
Claes Lundborg,
Preview
|
PDF (117KB)
|
|
ISSN:0025-116X
DOI:10.1002/macp.1961.020470108
出版商:Hüthig&Wepf Verlag
年代:1961
数据来源: WILEY
|
9. |
Über polyamide aus heterocyclischen dicarbonsäuren |
|
Die Makromolekulare Chemie,
Volume 47,
Issue 1,
1961,
Page 93-113
Von H. Hopff,
A. Krieger,
Preview
|
PDF (981KB)
|
|
摘要:
AbstractAus 21 heterocyclischen Dicarbonsäuren wurden lineare Polyamide hergestellt. Kondensationen durch Schmelzen von Hexamethylendiammoniumsalzen waren ungünstig, da die Produkte decarboxylierten, während Kondensationen über Ester etwas bessere Resultate gaben. Einige Salze ließen sich überhaupt nicht kondensieren.Mit 7 heterocyclischen Dicarbonsäurechloriden und verschiedenen Diaminen wurden Grenzflächenpolykondensationen durchgeführt, doch waren auch diese Polyamide in geschmolzenem Zustand nicht beständig.Molekulargewichtsbestimmungen zeigten, daß der Polykondensationsgrad nie über 30 lag.Vergleichsweise wurden Grenzflächenkondensate aus aromatischen Dicarbonsäuren oder Diaminen hergestellt. Es traten bei den heterocyclischen Derivaten keine grundsätzlich neuen Eigenschaften auf. Schmelzpunkte oder Löslichkeiten sind wegen des niederen Kondensationsgrades nicht eindeutig auf den Einfluß des Heterorings zurückzuführen.Es wird die Darstellung von zwei neuen Thiophendicarbonsäuren (Thiophen‐2,5‐diessigsäure und ‐2,5
ISSN:0025-116X
DOI:10.1002/macp.1961.020470109
出版商:Hüthig&Wepf Verlag
年代:1961
数据来源: WILEY
|
10. |
Studies on the polymerization of methacrylic esters. Part I. Polymerization ofn‐butyl methacrylate and isobutyl methacrylate |
|
Die Makromolekulare Chemie,
Volume 47,
Issue 1,
1961,
Page 114-127
A. S. Nair,
M. S. Muthana,
Preview
|
PDF (562KB)
|
|
摘要:
AbstractKinetics of the polymerization ofn‐butyl methacrylate and isobutyl methacrylate have been reported in this paper. The average degree of polymerization (DP) has been found to remain reasonably constant upto about 30 per cent conversion beyond which it is found to increase with conversion.The methacrylic esters are characterized by low chain transfer to monomer. Kifor both the esters have been determined. From a double logarithmic plot of [η] against M the values of K and α of the STAUDINGER‐KUHNequation have been obtained for the poly‐n‐butyl methacrylate. Using the values of K and α thus obtained molecular weights of fractionated samples of polyisobutyl methacrylate have been calculated. Attempt has been made to test the validity of PALIT's equation connecting
ISSN:0025-116X
DOI:10.1002/macp.1961.020470110
出版商:Hüthig&Wepf Verlag
年代:1961
数据来源: WILEY
|