1. |
Second Decennial Index |
|
Journal of Quality Technology,
Volume 21,
Issue 1,
1989,
Page 1-40
Preview
|
PDF (2979KB)
|
|
ISSN:0022-4065
DOI:10.1080/00224065.1989.11979147
出版商:Taylor&Francis
年代:1989
数据来源: Taylor
|
2. |
Some Thoughts on Variable-Selection in Multiple Regression |
|
Journal of Quality Technology,
Volume 21,
Issue 1,
1989,
Page 2-6
MandelJohn,
Preview
|
PDF (406KB)
|
|
摘要:
The practice of variable-selection in multiple linear regression is examined both logically and statistically in terms of the major objectives of regression analysis. It is argued that in addition to goodness-of-fit considerations, due attention should be given to determining the domain, in the space of regressors, in which the regression equation can be used as a prediction device. Such a domain has been called the“effective prediction domain”(EPD). It is shown that failure to do so can result in serious misuse of the regression equation, especially when regressors have been omitted.
ISSN:0022-4065
DOI:10.1080/00224065.1989.11979131
出版商:Taylor&Francis
年代:1989
数据来源: Taylor
|
3. |
Control-Charting Automated Laboratory Instruments When Many Successive Differences May Be Zero |
|
Journal of Quality Technology,
Volume 21,
Issue 1,
1989,
Page 7-15
CimineraJoseph L.,
TukeyJohn W.,
Preview
|
PDF (563KB)
|
|
摘要:
There is a need to monitor automated instruments used in the routine daily assay of body fluid samples from a clinical laboratory. The usual procedure is to prepare and make use of quality control charts for calibrations using purchased standard body fluids. These calibrations are dispersed within each batch of analytical samples. However, because of nonstandard conditions and other vagaries that occur with this type of measurement, ordinary quality control chart procedures may not be satisfactory. Clifford's scheme using absolute values of successive differences is modified to be effective when a large fraction of such differencesarezero. The modification should be effective in other circumstances where successive zero differencesare aproblem.
ISSN:0022-4065
DOI:10.1080/00224065.1989.11979132
出版商:Taylor&Francis
年代:1989
数据来源: Taylor
|
4. |
An Economic Evaluation of Improvements in Process Capability for a Single-Level Canning Problem |
|
Journal of Quality Technology,
Volume 21,
Issue 1,
1989,
Page 16-19
SchmidtRobert L.,
PfeiferPhillip E.,
Preview
|
PDF (298KB)
|
|
摘要:
Recent developments in quality improvement have emphasized variance reduction and created a need for methods to analyze the cost benefits that result from investments in increased conformance. In this paper we analyze the cost savings that result from a reduction in the process variance in a single-level canning problem. We present an approximation equation that provides a simple linear relationship between the percentage cost reduction and the percentage reduction in standard deviation.
ISSN:0022-4065
DOI:10.1080/00224065.1989.11979133
出版商:Taylor&Francis
年代:1989
数据来源: Taylor
|
5. |
The Power of theF-Test in Two-Factor Nested Experiments |
|
Journal of Quality Technology,
Volume 21,
Issue 1,
1989,
Page 20-23
SalviaAnthony A.,
LasherWilliam C.,
Preview
|
PDF (254KB)
|
|
摘要:
A tutorial review of two-factor nested experiments with random factors is presented. Results are given for the power of theF-test in such experiments.
ISSN:0022-4065
DOI:10.1080/00224065.1989.11979134
出版商:Taylor&Francis
年代:1989
数据来源: Taylor
|
6. |
Interval Estimation for Censored Accelerated Life Tests Based on the Lognormal Model |
|
Journal of Quality Technology,
Volume 21,
Issue 1,
1989,
Page 24-31
SchneiderHelmut,
WeissfeldLisa,
Preview
|
PDF (579KB)
|
|
摘要:
Simulation studies in this paper indicate that the standard large sample confidence intervals applied to censored samples from accelerated life tests tend to be too short for the required confidence level. Alternative confidence limits are derived which are asymptotically equivalent to the standard large sample confidence limits. These new confidence limits are asymmetric for finite-sized samples and produce a more accurate upper confidence limit. If the main point of an investigation is to determine whether the median or percentile lifetime is below a certain value, a one-sided confidence bound can be used and the proposed technique will yield more accurate results.
ISSN:0022-4065
DOI:10.1080/00224065.1989.11979135
出版商:Taylor&Francis
年代:1989
数据来源: Taylor
|
7. |
Generalized Attribute Acceptance Sampling Plans |
|
Journal of Quality Technology,
Volume 21,
Issue 1,
1989,
Page 32-40
NachlasJoel A.,
InSeong,
Preview
|
PDF (617KB)
|
|
摘要:
The imposition of acceptance criteria upon realizations of generalized sampling plans is described and shown to yield a large variety of new attribute acceptance sampling plans. The resulting generalized attribute acceptance sampling plans can be constructed to provide the same Operating Characteristic Curve as that for conventional single sampling plans with lower expected total cost. An example that illustrates this is presented.
ISSN:0022-4065
DOI:10.1080/00224065.1989.11979136
出版商:Taylor&Francis
年代:1989
数据来源: Taylor
|
8. |
Normal and Binomial Selection Problems |
|
Journal of Quality Technology,
Volume 21,
Issue 1,
1989,
Page 41-45
FriedrichsMichael D.,
GuentherWilliam C.,
Preview
|
PDF (412KB)
|
|
摘要:
Selection problems for normal means (assuming equal variances) and binomial probabilities of successarediscussed. For both caseskdistributions identified by these parameters are considered. The objective is to select, based on a random sample of size n from each of thekdistributions, a subset of size s distributions which contain the f distributions with the largest parameters (called thetbest) wherek>s≥t≥1. Minimum values of the probability of a correct selection are used to quantify the effectiveness of the procedures. Since these probabilities require numerical evaluation, user-friendly interactive computer programs (available upon request) have been prepared. Sample size problems are emphasized.
ISSN:0022-4065
DOI:10.1080/00224065.1989.11979137
出版商:Taylor&Francis
年代:1989
数据来源: Taylor
|
9. |
Procedures and Tables for the Selection of CSP-1 Plans |
|
Journal of Quality Technology,
Volume 21,
Issue 1,
1989,
Page 46-50
GovindarajuK.,
Preview
|
PDF (240KB)
|
|
摘要:
Procedures and tables are given for the selection of continuous sampling plans of type CSP-1 for a given set of conditions (AQL, AOQL) and (LQL, AOQL).
ISSN:0022-4065
DOI:10.1080/00224065.1989.11979138
出版商:Taylor&Francis
年代:1989
数据来源: Taylor
|
10. |
Computational Approaches to Estimating Negative Binomial Parameters from Count Data |
|
Journal of Quality Technology,
Volume 21,
Issue 1,
1989,
Page 51-64
DhavaleDileep G.,
Preview
|
PDF (773KB)
|
|
摘要:
A FORTRAN program is presented that estimates parameters of the negative binomial distribution from count data using different methods of estimation. The program also computes negative binomial probabilities from the estimated parameters and sums the probabilities within ranges of one to four standard deviations around the mean.
ISSN:0022-4065
DOI:10.1080/00224065.1989.11979139
出版商:Taylor&Francis
年代:1989
数据来源: Taylor
|