摘要:

Glucose oxidase was covalently immobilized onto a radio-frequency plasma-modified poly(etherurethaneurea). Thin (90-100 nm) plasma-polymerized N-vinyl-2-pyrrolidone films were deposited onto poly(etherurethaneurea) films. Active sites for the immobilization were obtained via reduction with aqueous sodium borohydride and activation with 1-cyano-4-dimethylaminopyridinium tetrafluoroborate. Modified poly(etherurethaneurea) films were assayed for binding and activity of the immobilized glucose oxidase layer. The results of a modified radioimmunoassay and an 'immunochemical stain' indicated that washing in 900 ml of continuously stirred 2% sodium dodecyl sulfate, 2% Triton X-100, and 20 mM sodium phosphate, pH 7.0, for 24 h each at 4°C was necessary to remove physically adsorbed glucose oxidase from the solid supports. An amperometric activity determination in 9 ml of well-stirred 20 mM sodium phosphate-0.1 M sodium chloride, pH 7.4, gave a qualitative demonstration of the activity of the immobilized enzyme on 18.75 cm2of modified poly(etherurethaneurea) film. A colorometric activity determination using the coupled reaction with o-dianisidine and peroxidase indicated that glucose oxidase covalently immobilized on approximately 2.4 cm2of modified poly(etherurethaneurea) film had an activity approximately equal to that of 13.4 nM glucose oxidase in 50 mM sodium acetate, pH 5.1, with a specific activity of approximately 32.0 U/mg at pH 5.1 and room temperature.

ISSN:0920-5063    

DOI:10.1163/156856292X00123

出版商:Taylor & Francis Group    

年代:1992

数据来源: Taylor

摘要:

The synthesis of a novel polyurethane block co-polymer containing a covalently attached, well-oriented RGD (Arg-Gly-Asp) peptide was explored. A poly(tetramethylene oxide) (PTMO)-based polyurethane was synthesized, and a bimolecular nucleophilic substitution reaction was then employed to incorporate ethyl carboxylate groups onto the polymer backbone (i.e. carboxylated polyurethane). Elemental analysis was used to determine the extent of carboxylation. The hexapeptide H-Gly-Arg-Gly-Asp-Ser-Tyr-OH was coupled to the carboxylated polyurethane via the formation of an amide bond. The attachment of the peptide was controlled by a protection-deprotection scheme. Nuclear magnetic resonance (NMR) and Fourier transform infrared (FTIR) spectroscopies were used to monitor the reactions. Sakaguchi assay and amino acid analysis confirmed that the RGD-containing peptide was successfully grafted onto the carboxylated polyurethane. This reaction scheme provides a new route for grafting end-linked, bioactive peptides onto polyurethanes.

ISSN:0920-5063    

DOI:10.1163/156856292X00132

出版商:Taylor & Francis Group    

年代:1992

数据来源: Taylor

摘要:

Polyurethane (PU) surface was chemically modified by grafting of perfluorodecanoic acid (PFDA) to produce a highly hydrophobic surface to compare the blood compatability with hydrophilic poly(ethylene oxide) (PEO) grafted PUs. The advancing contact angle of modified PU-PFDA was increased up to 115 deg, while that of untreated PU was 86 deg. The PFDA grafted PU exhibited less adhesion and shape change of platelets than untreated PU, and the activated partial thromboplastin time (APTT) of PU-PFDA was considerably extended. The ex vivo occlusion time of untreated PU was only 50 min, but that of PFDA grafted PU was extended to 130 min, indicating that this hydrophobic surface is significantly blood compatible. It is interesting to find that the enhanced blood compatibility of very hydrophobic PU-PFDA was equivalent to hydrophilic PU-PEO.

ISSN:0920-5063    

DOI:10.1163/156856292X00141

出版商:Taylor & Francis Group    

年代:1992

数据来源: Taylor

摘要:

'On-off' regulation of drug permeation through membranes in response to external temperature change has already been achieved using thermosensitive copolymers of N-isopropyl acrylamide (IPAAm) with butyl methacrylate (BMA). Increasing temperature induced formation of a dehydrated polymeric surface skin layer that stopped drug permeation. In this study, to control 'on-off' permeability of a drug, the polymer surface shrinking process was regulated by changing the length of alkyl side chain of the copolymer methacrylate component. Permeation experiments with indomethacin were performed in response to stepwise temperature changes between 20 and 30°C with copolymers of IPAAm with BMA, hexyl methacrylate (HMA), and lauryl methacrylate (LMA). Burst permeation was found at the initial stage of the second 'on' period for both poly(IPAAm-co-HMA) and poly(IPAAm-co-LMA). These results suggest that drug diffuses during 'off' periods to change the concentration profile in the polymer gel. Polymer surface skin formation maintains a localized high water content inside the polymer gel even if drug permeation stops. The length of the alkyl side chain is an important parameter to control 'on-off' permeability of drug.

ISSN:0920-5063    

DOI:10.1163/156856292X00150

出版商:Taylor & Francis Group    

年代:1992

数据来源: Taylor

摘要:

Adhesion and proliferation of bovine aortic endothelial cells on polystyrene derivatives having monoamine or diamine side chain was investigated focusing on the chemical structure of amino groups. Copolymers, SE8.5, is composed of polystyrene with 8.5 mol% of monoamine side chains, and SED8, which is with 8 mol% of diamine side chains, were estimated to contain almost the same amount of protonated amino groups in bulk composition at physiological pH (pH 7.4). There observed significant difference in cellular spreading of attached endothelial cells between these two types of copolymer surfaces. Spreading-% of attached cells on SED8 surfaces was approximately 1.6 times greater than that on SE8.5 6 h after seeding. This difference in cellular spreading influenced to subsequent cell growth. Cellular growth on each polymer surface was featured by parameter k, which corresponds to the 'rate constant' of cellular proliferation. While the k-value for SE8.5 decreased with decreasing seeding density as well as the case for polystyrene, SED8 maintained a high k-value even at low seeding density as 2 x 103cells/ cm2. These results suggest that cells may recognize the difference in the chemical structure of amine side chains of SE and SED copolymers.

ISSN:0920-5063    

DOI:10.1163/156856292X00169

出版商:Taylor & Francis Group    

年代:1992

数据来源: Taylor

摘要:

A process of freeze-thaw polymerization involving the low temperature photopolymerization of a mixed solution of monomers and bovine serum albumin around frozen ice crystals has been used to generate a bead formed macroporous hydrophilic matrix with potential for sustained release. Beads over the size range 100-3000 μm were fabricated with surface and internal pores of between 0.7-2.6 μm whose diameter could be controlled by manipulation of the monomers to solvent ratio. Increasing both the proportion of monomers in the monomer solution and the percentage of BSA incorporated reduced the EWC of beads. The BSA release profile was characterized by an initial burst followed by a lower but sustained release lasting up to 1 month. The total cumulative release of BSA and the proportion of the incorporated BSA load subsequently released were both reduced in physiological saline compared with distilled water but enhanced by freeze drying, mild agitation and incubation at 37°C.

ISSN:0920-5063    

DOI:10.1163/156856292X00178

出版商:Taylor & Francis Group    

年代:1992

数据来源: Taylor