1. |
Research at Thyssen Stahl AG, Duisburg |
|
Archiv für das Eisenhüttenwesen,
Volume 57,
Issue 9,
2016,
Page 419-426
Preview
|
PDF (1227KB)
|
|
ISSN:0003-8962
DOI:10.1002/srin.198600796
出版商:Wiley
年代:2016
数据来源: WILEY
|
2. |
The continuous analysis of molten steel by means of chemical reactions/aerosol generation and atomic emission spectrometry |
|
Archiv für das Eisenhüttenwesen,
Volume 57,
Issue 9,
2016,
Page 427-429
Alfred Golloch,
Preview
|
PDF (231KB)
|
|
摘要:
For the continuous analysis of molten steel there are three fundamental alternatives to attain information about the concentrations of elements in the melt. The method of continuous sampling and analyzing the material of the sample stream outside the melt is chosen for investigation in the present work.
ISSN:0003-8962
DOI:10.1002/srin.198600797
出版商:Wiley
年代:2016
数据来源: WILEY
|
3. |
ECSC announcements |
|
Archiv für das Eisenhüttenwesen,
Volume 57,
Issue 9,
2016,
Page 429-429
Preview
|
PDF (77KB)
|
|
ISSN:0003-8962
DOI:10.1002/srin.198600798
出版商:Wiley
年代:2016
数据来源: WILEY
|
4. |
Zusammenhang zwischen dem Oxidationsgrad der Eisenoxide und den Verteilungswerten des Schwefels beim Gleichgewicht zwischen Eisenschmelzen und MgO‐gesättigten Stahlwerksschlacken |
|
Archiv für das Eisenhüttenwesen,
Volume 57,
Issue 9,
2016,
Page 430-435
Eberhard Schürmann,
Ingo Kolm,
Preview
|
PDF (638KB)
|
|
摘要:
Die Oxidationsgrade der Eisenoxide in MgO‐gesättigten Stahlwerksschlacken beim Gleichgewicht mit flüssigem Eisen wurden durch Auswertung zahlreicher im Schrifttum mitgeteilter Versuchsergebnisse bestimmt und ihre Abhängigkeit von der Schlak‐kenzusammensetzung dargestellt.Desgleichen wurde das Entschwefelungsvermögen MgO‐gesättigter Stahlwerksschlacken anhand der Gleichgewichtsverteilungswerte beschrieben. Es wird festgestellt, daß optimale Ergebnisse nur bei gleichzeitiger Kalksättigung zu erzielen sind.Ein Zusammenhang zwischen der Schwefelverteilung und dem dreiwertigen Eisengehalt der Schlacke konnte aufgezeigt und durch Bildung von auf dem dreiwertigen Eisenoxid basierenden Oxisulfiden gedeutet werden.
ISSN:0003-8962
DOI:10.1002/srin.198600799
出版商:Wiley
年代:2016
数据来源: WILEY
|
5. |
Activities of FexO in CaO + CaF2+ SiO2+ FexO quaternary slags by disposable electrochemical oxygen probes |
|
Archiv für das Eisenhüttenwesen,
Volume 57,
Issue 9,
2016,
Page 436-443
Masanori Iwase,
Hiroshi Akizuki,
Eiji Ichise,
Yoshitaka Tanaka,
Preview
|
PDF (682KB)
|
|
摘要:
The activities of FexO in CaO + CaF2+ SiO2+ FexO quaternary slags were measured by means of solid‐oxide galvanic cell. The FexO activities in the slags are influenced by CaF2as well as SiO2. At constant FexO mole fractions, e.g.,, at low SiO2mole fractions i.e.,, the substitution of CaF2for CaO has an effect of raising the FexO activity. At higher SiO2mole fractions, e.g.,, however, such an effect becomes insignificant.
ISSN:0003-8962
DOI:10.1002/srin.198600800
出版商:Wiley
年代:2016
数据来源: WILEY
|
6. |
Aufnahme von Tonerde durch Stranggießpulver |
|
Archiv für das Eisenhüttenwesen,
Volume 57,
Issue 9,
2016,
Page 444-451
Thuong Thoi Do,
Klaus W. Lange,
Preview
|
PDF (670KB)
|
|
摘要:
Anhand von mit Aluminium desoxidierten Eisenschmelzen wird die Tonerdeaufnahmegeschwindigkeit handelsüblicher Stranggießpulver untersucht. Die Tonerdeaufnahmevermögen der untersuchten Gießpulver liegen über 20 Gew.‐%, so daß sie sich in dieser Beziehung in der Praxis gut bewähren können. Die Abhängigkeit der Tonerdeaufnahmegeschwindigkeit von der Basizität (CaO/SiO2) zeigt ein Minimum. An der Phasengrenze Gießpulver/Schmelze beträgt der anfängliche Tonerdeübergang 1,78 mg/cm2.s.
ISSN:0003-8962
DOI:10.1002/srin.198600801
出版商:Wiley
年代:2016
数据来源: WILEY
|
7. |
Thermodynamic and transport properties of binary gas‐mixtures |
|
Archiv für das Eisenhüttenwesen,
Volume 57,
Issue 9,
2016,
Page 452-458
Wilfried Lyhs,
Preview
|
PDF (511KB)
|
|
摘要:
By fitting approximation functions to thermodynamic and transport properties of binary mixtures, tables of these properties can be given in a compressed form. As an example the tabulation is carried out for an oxygen‐nitrogen mixture.
ISSN:0003-8962
DOI:10.1002/srin.198600802
出版商:Wiley
年代:2016
数据来源: WILEY
|
8. |
Phase equilibrium in the system ZrO2+ MgO + P2O5at 1573 K |
|
Archiv für das Eisenhüttenwesen,
Volume 57,
Issue 9,
2016,
Page 459-460
Masanori Iwase,
Eiji Ichise,
Hitoshi Kitaguchi,
Preview
|
PDF (155KB)
|
|
摘要:
Phase equilibrium in the system ZrO2+ MgO + P2O5near ZrO2—MgO edge was established at 1 573 K. Within the composition range investigated pseudoternary compounds were not detected, while two compatibility triangles for ZrO2+ MgO + 3MgO · P2O5and ZrO2+ 3 MgO · P2O5+ 2ZrO2· P2O5were determined.
ISSN:0003-8962
DOI:10.1002/srin.198600803
出版商:Wiley
年代:2016
数据来源: WILEY
|
9. |
Process conditions and oxidation behaviour of high speed steel ribbons during rapid quenching |
|
Archiv für das Eisenhüttenwesen,
Volume 57,
Issue 9,
2016,
Page 461-465
Wolfgang Löser,
Günter Stephani,
Hans Fiedler,
Preview
|
PDF (523KB)
|
|
摘要:
Oxygen absorption has been investigated in rapidly quenched ribbons of high speed steel produced by a single roller PFC‐technique. The average oxygen content of the master alloy was 130 ppm. After melt spinning, there was an increase in the oxygen level from 700 to 10 000 ppm depending on the ribbon thickness and on the ribbon‐roller contact length. Using IR‐temperature measurements, the oxygen content correlates with the ribbon temperature at the ribbon‐roller separation point. The oxygen levels rise with increasing ribbon thickness or decreasing contact length. Quenching rates are strongly affected by the wetting conditions of the solidifying ribbon at the roller surface. Secondary oxidation was interpreted using a phenomenological model for the scale constantwhich produced calculated data in reasonable agreement with the experimental results. Aspects for process improvement are also discussed.
ISSN:0003-8962
DOI:10.1002/srin.198600804
出版商:Wiley
年代:2016
数据来源: WILEY
|
10. |
An improved calculation of the transformation of steels |
|
Archiv für das Eisenhüttenwesen,
Volume 57,
Issue 9,
2016,
Page 466-471
Hans Paul Hougardy,
Kazumasa Yamazaki,
Preview
|
PDF (554KB)
|
|
摘要:
For the calculation of the transformation of steels during continuous cooling a new method is proposed. For isothermal transformation the temperature dependence of 1% and 99% transformation of austenite is described by a function which can well be fitted to measured values. This function allows an extrapolation beyond the measured values giving good agreement between calculated and measured TTT‐diagrams. For continuous cooling it is possible to calculate the transformation below Ms. The agreement between calculated and measured values of the volume fractions of different microstructural constituents at room temperature after continuous cooling is good.
ISSN:0003-8962
DOI:10.1002/srin.198600805
出版商:Wiley
年代:2016
数据来源: WILEY
|