1. |
Research at Thyssen Stahl AG, Duisburg |
|
Archiv für das Eisenhüttenwesen,
Volume 57,
Issue 8,
2016,
Page 349-355
Preview
|
PDF (683KB)
|
|
ISSN:0003-8962
DOI:10.1002/srin.198600781
出版商:Wiley
年代:2016
数据来源: WILEY
|
2. |
Model investigations on the penetration of melts into injection nozzles |
|
Archiv für das Eisenhüttenwesen,
Volume 57,
Issue 8,
2016,
Page 356-360
Byung‐Don You,
Wolfgang Polanschütz,
Herbert Hiebler,
Preview
|
PDF (608KB)
|
|
摘要:
The formation of gas bubbles and the penetration behaviour of the liquid into the nozzle against the gas stream were studied in water, water‐glycerine mixtures and mercury from bubbling regions to a continuous gas jet region with various nozzle configuration.Measurements were also made with gas and powder injection in the mercury and molten pig iron models. It was observed that the penetration behaviour of the liquids during gas injection depends on the gas flow velocity, the diameter and orientation of the nozzle, the wettability and the density of the liquid. The results of the powder injection showed a lower penetration depth of the liquid into the nozzle than the results for gas only injections. The effect of each influencing factor on the penetration behaviour was shown to be similar in both injection types, with or without powder.
ISSN:0003-8962
DOI:10.1002/srin.198600782
出版商:Wiley
年代:2016
数据来源: WILEY
|
3. |
Thermodynamic calculation of phase diagrams in the iron‐nitrogen system |
|
Archiv für das Eisenhüttenwesen,
Volume 57,
Issue 8,
2016,
Page 361-367
Joachim Kunze,
Preview
|
PDF (690KB)
|
|
摘要:
On the basis of recent measurements of the equilibria between N2and NH3containing gas atmospheres, respectively, and of the nitrogen solved in the α, γ and ε iron phases a thermodynamic analysis of the Fe—N system has been carried out. The Gibbs free energy of the γ, ε transformation of pure iron was derived. The composition Fe4.3N was calculated concerning the γ’ phase above 593°C.The phase boundaries were stated as temperature functions of the N2equilibrium pressures. The resulting phase diagram shows the stability regions of the α, γ, γ’ and ε phases and an α/γ/ε triple point which corresponds to that of the pure iron.
ISSN:0003-8962
DOI:10.1002/srin.198600783
出版商:Wiley
年代:2016
数据来源: WILEY
|
4. |
Strömung expandierender Gase durch verdichtete Haufwerke |
|
Archiv für das Eisenhüttenwesen,
Volume 57,
Issue 8,
2016,
Page 368-372
Wolfgang Horrighs,
Georg Bauckelmann,
Preview
|
PDF (544KB)
|
|
摘要:
Die bei der Durchströmung von Schüttungen verwendeten Widerstandsgesetze stützen sich auf charakteristische Kenngrößen von Schüttgütern, die eine absolut lose Strukturierung besitzen. Bei einem derart ideal vorliegenden Haufwerk geht man davon aus, daß eine stochastische und gleichmäßige Anordnung von Strömungskanälen existiert, wobei jegliche Veränderung des Durchströmungsverhaltens bei einer Neuorientierung der Schüttung eindeutig durch eine zu messende Veränderung ihrer Gesamtporosität beschrieben werden kann. Geringe Drücke bei leicht plastizierbaren Stoffen durch Lagerung bzw. Transport und Füllung oder zusätzliche thermische Beeinflussung im Betrieb führen jedoch zu einer teilweisen Verdichtung des Feststoffes und damit zu einem Zusetzen von Strömungskanälen, so daß die für die Durchströmung eines Gases zur Verfügung stehende Porosität geringer wird als dies die meßtechnisch erfaßbare Veränderung der Gesamtporosität beschreiben könnte. Dies führt dazu, daß der Druckverlust auch bereits bei leicht verdichteten Schüttgütern höher ausfallen kann und damit eine Durchströmbarkeit vorliegt, die geringer ist als die aus den normalen Widerstandsgesetzen für lose Schüttungen ermittelte.
ISSN:0003-8962
DOI:10.1002/srin.198600784
出版商:Wiley
年代:2016
数据来源: WILEY
|
5. |
Application of the theory of rolling to rolling in the case of mill vibrations |
|
Archiv für das Eisenhüttenwesen,
Volume 57,
Issue 8,
2016,
Page 373-376
Oskar Pawelski,
Wolfgang Rasp,
Klaus Friedewaid,
Preview
|
PDF (286KB)
|
|
摘要:
Knowledge of the reactions of the roll gap according to variable gap geometry, especially of the roll force as a function of vertical displacement of the work rolls, is required to calculate the oscillatory behaviour of the roll stand.The basic equations describing the pressure distribution in the roll gap with variable geometry are formulated using the methods of continuum mechanics. The flattening of the work rolls is taken into account by using Hitchcock's formula. Exemplary calculations show that during vibration the tension between the stands can vanish or the neutral point can surpass the roll gap exit. Both effects may result in tearing the strip at the entry of the affected mill stand.
ISSN:0003-8962
DOI:10.1002/srin.198600785
出版商:Wiley
年代:2016
数据来源: WILEY
|
6. |
Beitrag zur Klärung des unstetigen Austenitkornwachstums in mikrolegierten Feinkornbaustählen |
|
Archiv für das Eisenhüttenwesen,
Volume 57,
Issue 8,
2016,
Page 377-384
Andreas Kern,
Winfried Reif,
Preview
|
PDF (1005KB)
|
|
摘要:
Die zur Beschreibung der Kornwachstumsvorgänge des Austenits in mikrolegierten Stählen vorliegenden qualitativen und quantitativen Beschreibungen können in einer geschlossenen Darstellung zusammengefaßt werden, die als konservative Beschreibung des Kornwachstums bezeichnet wird. Hierin wird ein kritischer Teilchenzustand der kornwachstumsbehindernden Karbonitride bezüglich der Teilchengröße und ‐verteilung unter Berücksichtigung der Rückhaltekraft der Teilchen und der Definition des GefügeheterogenitätsgradesZbeschrieben. Von dessen Definition hängt entscheidend die Bedeutung des kritischen Zustandes ab. Innerhalb der konservativen Beschreibung kann jedoch nur stetiges Kornwachstum vorliegen. Eine Erweiterung auf die nichtkonservative Beschreibung soll das unstetige Kornwachstum klären. Die Erscheinung des unstetigen Kornwachstums wird hierbei auf das Vorhandensein von zwei Teilgefügen bei der niedrigsten betrachteten Austenitisierungstemperatur zurückgeführt. Der HeterogenitätsgradZwird als Verhältnis der Größen beider Teilgefüge definiert, womit der kritische Zustand den Beginn des beschleunigten Wachstums eines Teilgefüges gegenüber dem anderen kennzeichnet. Diese zwei Wachstumsvorgänge, die unterschiedlichem Anstieg folgen, beschreiben als integraler Effekt das unstetige Kornwachstum. Austenitisierungsversuche an drei mikrolegierten Stählen mit konstanter Glühzeit zeigen bei der statistischen Analyse tatsächlich zwei Teilgefüge bei der niedrigsten Austenitisierungstemperatur. Das oberhalb einer bestimmten Temperatur einsetzende beschleunigte Wachsen eines Teilgefüges bzw. die schnelle Zusammenführung zu einem Gesamtgefüge können metallografisch als unstetiges Kornwachstum beobachtet werden. Die berechneten Temperaturen für den kritischen Zustand stimmen weitgehend mit den experimentell ermittelten Temperaturen für den Beginn des unstetigen Kornwachstums überein. Diese Tatsachen belegen die Beurteilung des Kornwachstums innerhalb der nichtkonservativen Beschreibung. Das Vorhandensein zweier Teilgefüge am Wachstumsursprung kann auf Seigerungen der Elemente Mn und Si zurückgeführt werden.
ISSN:0003-8962
DOI:10.1002/srin.198600786
出版商:Wiley
年代:2016
数据来源: WILEY
|
7. |
Analysis of grain boundary movement analogous to dislocation movement – both with a matrix having precipitates |
|
Archiv für das Eisenhüttenwesen,
Volume 57,
Issue 8,
2016,
Page 385-388
Andreas Kern,
Winfried Reif,
Preview
|
PDF (363KB)
|
|
摘要:
In the present investigation it has been shown exemplarily for an austenite microstructure containing carbonitrides that the specific restraining force of a grain boundary due to the distribution of precipitates can be described by a modified Orowan's law, so that the grain boundary movement is considered to be analogous to the dislocation movement. This is achieved by using a modified restraining forceFr(corresponding to the cubic geometry of the particles), a detailed thermodynamic analysis of the precipitates (in this case, carbonitrides) and selected relation for the interparticle spacingLa. The specific restraining force and the interparticle spacing depend on temperature within the austenite range. Each temperature is attached to a couple (Fr/La). The plotFragainstshows straight lines for each steel and from their average slope, a shear moduleG'of grain boundaries, which is about 64300 N·cm−2, is obtained. Hence, it is possible to describe the specific restraining force of a grain boundary with the help of Orowan's law or as it is conventionally done by using Zener's modell.At a critical temperatureT*, which is different for each steel, the specific restraining force is equal to the driving force of the grain boundary. The corresponding values ofLaare also different for each steel and the steel which is the most resistant to grain coarsening is allowed to have the greatest value ofLawhich still retains the capacity of impeding grain coarsening.
ISSN:0003-8962
DOI:10.1002/srin.198600787
出版商:Wiley
年代:2016
数据来源: WILEY
|
8. |
ECSC announcements |
|
Archiv für das Eisenhüttenwesen,
Volume 57,
Issue 8,
2016,
Page 388-388
Preview
|
PDF (89KB)
|
|
ISSN:0003-8962
DOI:10.1002/srin.198600788
出版商:Wiley
年代:2016
数据来源: WILEY
|
9. |
Determination of contrast in automatic quantitative microstructure analysis |
|
Archiv für das Eisenhüttenwesen,
Volume 57,
Issue 8,
2016,
Page 389-391
Bernhard Schröer,
Hans Paul Hougardy,
Preview
|
PDF (256KB)
|
|
摘要:
For the automatic quantitative measurement of microstructures in general television‐based systems are used. To guarantee a defined accuracy of the measurement, these systems need a minimum contrast between different phases. This contrast is calculated for different numbers of phases and measuring conditions. The result can be used to calculate type and thickness of interference layers to realize these contrasts.
ISSN:0003-8962
DOI:10.1002/srin.198600789
出版商:Wiley
年代:2016
数据来源: WILEY
|
10. |
ECSC announcements |
|
Archiv für das Eisenhüttenwesen,
Volume 57,
Issue 8,
2016,
Page 392-392
Preview
|
PDF (92KB)
|
|
ISSN:0003-8962
DOI:10.1002/srin.198600790
出版商:Wiley
年代:2016
数据来源: WILEY
|