1. |
Centre de Recherches Métallurgiques Centrum voor Research in de Metallurgie (C. R. M.) |
|
Archiv für das Eisenhüttenwesen,
Volume 57,
Issue 4,
2016,
Page 141-147
Preview
|
PDF (1467KB)
|
|
ISSN:0003-8962
DOI:10.1002/srin.198600745
出版商:Wiley
年代:2016
数据来源: WILEY
|
2. |
Reaktionsmechanismen und Abbrandgeschwindigkeit mit Luft angeströmter Kohlenstoffteilchen |
|
Archiv für das Eisenhüttenwesen,
Volume 57,
Issue 4,
2016,
Page 148-159
Eckehard Specht,
Rudolf Jeschar,
Preview
|
PDF (1199KB)
|
|
摘要:
Der Einfluß der beiden heterogenen Oberflächenreaktionen C+CO2→ 2 CO und 2C+O2→ 2 CO und der homogenen Reaktion in der Gasphase 2 CO + O2→ 2 CO2auf den Kohlenstoffabbrand wurde anhand angeströmter plattenförmiger Teilchen untersucht. Bei hohen Temperaturen (Dav>30,DaB>15) stellt sich ein zweistufiger Reaktionsmechanismus ein, nämlich Boudouard‐Reaktion an der Oberfläche und CO‐Verbrennung in der Gasphase. Der Kohlenstoffabbrand ist dann doppelt so groß wie der Stoffübergang, was in der Molzahlerhöhung bei der Vergasung begründet ist. Die Abbrandgeschwindigkeit wird im wesentlichen durch die chemische Kinetik der beiden heterogenen Reaktionen bestimmt, während der Einfluß der chemischen Kinetik der Gasreaktion, der vom Verhältnis der heterogenen Reaktionsgeschwindigkeiten abhängt, vergleichsweise gering ist. Da die Bedeutung der Reaktion 2 C + O2→ 2 CO während des Ausbrands einer Flamme aufgrund des O2‐Umsatzes abnimmt und die der Boudouard‐Reaktion mit der CO2‐Produktion zunimmt, haben beide Reaktionen noch ungefähr gleichen Anteil am Umsatz, selbst wenn die Geschwindigkeit der Boudouard‐Reaktion um den Faktor 100 kleiner ist. Für einige Fälle werden anhand von Grenzschichtverläufen für Konzentration und Temperatur die starke Kopplung beider Felder gezeigt. In Allen Fällen wurde von dichten Kohlenstoffteilchen ausgegangen, so daß der mögliche Einfluß der Porendiffusion vernachlässigt werden konnte.
ISSN:0003-8962
DOI:10.1002/srin.198600746
出版商:Wiley
年代:2016
数据来源: WILEY
|
3. |
The CO2solubilities of highly basic melts |
|
Archiv für das Eisenhüttenwesen,
Volume 57,
Issue 4,
2016,
Page 160-165
Tetsuro Kawahara,
Kazuo Yamagata,
Nobuo Sano,
Preview
|
PDF (456KB)
|
|
摘要:
The CO2solubilities of highly basic melts have been measured by equilibrating samples with a gas phase. According to the results, the investigated oxides can be arranged as follows in order of decreasing basicity; K2O>Na2O>Li2O, BaO>CaO, SO3≍ CrO3>BO1.5>SiO2>PO2.5. By comparing the solubility data with optical theoretical basicity value, sulfide capacity, phosphate capacity and activity of CaO, it has been found that the carbonate capacity is a good measure of slag basicity.
ISSN:0003-8962
DOI:10.1002/srin.198600747
出版商:Wiley
年代:2016
数据来源: WILEY
|
4. |
A New Silicon Sensor for Hot Metal Measurements |
|
Archiv für das Eisenhüttenwesen,
Volume 57,
Issue 4,
2016,
Page 166-171
Kiyoshi Ichihara,
Dieter Janke,
Hans‐Jürgen Engell,
Preview
|
PDF (759KB)
|
|
摘要:
In the present study, an electrochemical sensor has been designed for the direct measurement of silicon content in hot metal. The sensor represents a galvanic silicon concentration cell of the typeNisat—Si(1) II silicate electrolyte (1) II Fe—C—Si(1)The tubular silica‐glass sensor can be immediately immersed into the metal bath at a response time of 30 to 60 s. A reproducible EMF vs. wt.% Si relationship was obtained for measurements in carbon‐saturated Fe—C—Si melts at 1400°C and Si contents from 0.05 to 1.8 wt.%. This relationship is nearly identical with the cell function calculated from thermodynamic data.
ISSN:0003-8962
DOI:10.1002/srin.198600748
出版商:Wiley
年代:2016
数据来源: WILEY
|
5. |
Present quality level of large heat resistant rotor forgings made of 1% CrMoV steel – Part II |
|
Archiv für das Eisenhüttenwesen,
Volume 57,
Issue 4,
2016,
Page 172-177
Jürgen Ewald,
Christina Berger,
Karl‐Heinz Keienburg,
Werner Wiemann,
Preview
|
PDF (1505KB)
|
|
摘要:
While in part I mainly mechanical and toughness properties together with structural aspects have been dealt with now design properties are described. The basic properties for heat resistant rotor materials are traditionally the creep properties. So they are here investigated more in detail and it is shown that modern 1% CrMoV rotor steels have a quite similar creep behaviour both oil and air quenched. Long term high temperature exposure and its influence on the properties are as well mentioned as heat stability behaviour.
ISSN:0003-8962
DOI:10.1002/srin.198600749
出版商:Wiley
年代:2016
数据来源: WILEY
|
6. |
Surface and grain boundary segregation on and in iron |
|
Archiv für das Eisenhüttenwesen,
Volume 57,
Issue 4,
2016,
Page 178-185
Hans Jürgen Grabke,
Preview
|
PDF (688KB)
|
|
摘要:
The equilibrium segregationA(dissolved) =A(segregated), whereA= C, Si, Sn, N, P, O, S … is studied for binary systems Fe‐Ain the stability range of the α‐solid solution using surface‐analytical methods. On the surfaces ordered structures were observed by LEED and surface concentrations were determined by AES – in dependence on bulk concentrations and temperature. The chemical binding state was characterized by XPS. In grain boundaries the segregation was determined by AES after intergranular fracture of samples.A survey is given of the existing results.
ISSN:0003-8962
DOI:10.1002/srin.198600750
出版商:Wiley
年代:2016
数据来源: WILEY
|
7. |
News from the Max‐Planck‐Institut für Eisenforschung GmbH |
|
Archiv für das Eisenhüttenwesen,
Volume 57,
Issue 4,
2016,
Page 186-186
Preview
|
PDF (110KB)
|
|
ISSN:0003-8962
DOI:10.1002/srin.198600751
出版商:Wiley
年代:2016
数据来源: WILEY
|