|
11. |
Wear Behaviour of Stainless Steelafter Al2O3Plasma Spraying for Biomedical Applications |
|
Surface Engineering,
Volume 6,
Issue 3,
1990,
Page 209-212
SantosJ. D. S.,
MonteiroF. J.,
Preview
|
PDF (1373KB)
|
|
摘要:
AbstractA promising use of metallic alloys such as stainless steels, Cr-Co-Mo alloys, and titanium alloys coated with ceramics such as alumina or hydroxyapatite is in biomaterial applications. This procedure can lead to a good combination of properties: corrosion and wear resistance and beneficial bioreactivity from the coating, together with the necessary high yield strength and toughness of the metallic substrates. Results of wear tests on AISI 316L stainless steel, with and without alumina coatings, are presented. The adhesion of the coatings has also been evaluated.
ISSN:0267-0844
DOI:10.1179/sur.1990.6.3.209
出版商:Taylor&Francis
年代:1990
数据来源: Taylor
|
12. |
Fabrication, Microstructure, and Wear of Al-10.6Si Laser Surface Alloyed with Additional Silicon |
|
Surface Engineering,
Volume 6,
Issue 3,
1990,
Page 213-218
TomlinsonW. J.,
McAraJ. R.,
BransdenA. S.,
Preview
|
PDF (1831KB)
|
|
摘要:
AbstractA cast Al-10.6 Si alloy has been laser surface alloyed with 9.4, 15, 19, and 35% Si, the coatings have been characterised, and the dry sliding wear against a cast iron surface has been investigated. Except for a few pores, the coatings were relatively uniform in composition, microstructure, and thickness, and had high integrity and continuity with the substrate. The microstructure was very fine, the eutectic composition being displaced to approximately 17% Si. The wear rates of the base alloy, the laser surface melted base alloy, and the laser surface alloyed coatings were similar. The microstructures of the worn pins and the worn cast iron rings are described and discussed. The mechanism of wear is by adhesion, extensive plastic flow, and fracture.
ISSN:0267-0844
DOI:10.1179/sur.1990.6.3.213
出版商:Taylor&Francis
年代:1990
数据来源: Taylor
|
13. |
Discussion on‘Is a second layer really necessary?’ |
|
Surface Engineering,
Volume 6,
Issue 3,
1990,
Page 219-220
WormersleyD.,
Preview
|
PDF (63KB)
|
|
ISSN:0267-0844
DOI:10.1179/sur.1990.6.3.219
出版商:Taylor&Francis
年代:1990
数据来源: Taylor
|
14. |
Influence of Ti intermediate layer on properties of TiN coatings deposited on various substrates |
|
Surface Engineering,
Volume 6,
Issue 3,
1990,
Page 220-220
Van StappenM.,
MallietB.,
De SchepperL.,
StalsL. M.,
CelisJ. P.,
RoosJ. R.,
Preview
|
PDF (33KB)
|
|
ISSN:0267-0844
DOI:10.1179/sur.1990.6.3.220
出版商:Taylor&Francis
年代:1990
数据来源: Taylor
|
|