1. |
Measurement of Fast Transient and Steady‐State Responses of Viscoelastic Fluids with a Sliding Cylinder Rheometer Executing Coaxial Displacements |
|
Transactions of the Society of Rheology,
Volume 29,
Issue 1,
1985,
Page 1-18
A. T. Tsai,
D. S. Soong,
Preview
|
PDF (879KB)
|
|
摘要:
A sliding cylinder rheometer (SCR) has been constructed for use with an existing materials test system (MTS) for the measurement of fast transient and steady‐state responses of viscoelastic fluids in simple shear. This MTS‐SCR combination capitalizes on the versatility and capability of the MTS programmable drive system, while the design of the SCR ensures the ideal simple shearing configuration. Experience with this new system indicates that SCR is not only less expensive to construct but also easier to use than the parallel‐plate rheometer (PPR). Instrumental compliance, material inertia, and mechanical lag in both the input and output components of the system are minimal. Reproducible shear stress data on a polyisobutylene‐in‐decalin solution have been obtained for various complicated flow programs.
ISSN:0148-6055
DOI:10.1122/1.549783
出版商:The Society of Rheology
年代:1985
数据来源: AIP
|
2. |
A Viscometer for Fast Polymerizing Systems |
|
Transactions of the Society of Rheology,
Volume 29,
Issue 1,
1985,
Page 19-36
S. J. Perry,
J. M. Castro,
C. W. Macosko,
Preview
|
PDF (757KB)
|
|
摘要:
A parallel‐disk viscometer capable of measuring the viscosity rise isothermally for fast polymerizing systems has been designed and characterized. Criteria for isothermal operation are given. The viscometer has been specifically designed for polyurethane chemical systems used in reaction injection molding (RIM) and is adaptable enough to be coupled directly to various commercial RIM machines. Some minor modifications may be needed for other reactive systems. The viscometer in its present design is not highly precise, but is rugged and inexpensive.
ISSN:0148-6055
DOI:10.1122/1.549784
出版商:The Society of Rheology
年代:1985
数据来源: AIP
|
3. |
Flow of a Polar Fluid between Two Eccentric Rotating Cylinders |
|
Transactions of the Society of Rheology,
Volume 29,
Issue 1,
1985,
Page 37-48
M. T. Kamel,
Preview
|
PDF (403KB)
|
|
摘要:
The flow of a creeping polar fluid between two eccentric rotating cylinders is analyzed. A perturbation series is applied to solve the system of partial differential equations. The dependence of the velocity components and the spin on the coupling numberNand the length ratioLis discussed.
ISSN:0148-6055
DOI:10.1122/1.549785
出版商:The Society of Rheology
年代:1985
数据来源: AIP
|
4. |
Characterization Method for a Class of Thermorheologically Complex Materials |
|
Transactions of the Society of Rheology,
Volume 29,
Issue 1,
1985,
Page 49-66
B. D. Harper,
Y. Weitsman,
Preview
|
PDF (694KB)
|
|
摘要:
The article presents a method for modeling the response of a class of thermorheologically complex viscoelastic materials. For the type of materials considered, all temperature effects can be correlated through horizontal and vertical shift factors. In addition, the proper evaluation of transient temperature response requires the vertical shift to be represented as a product of two temperature‐dependent functions. It is shown that, in order to obtain complete information, it is necessary to conduct sharp temperature‐drop tests in addition to isothermal creep and recovery experiments. The method and its use are demonstrated for the specific case of Hercules 3502 epoxy resin.
ISSN:0148-6055
DOI:10.1122/1.549786
出版商:The Society of Rheology
年代:1985
数据来源: AIP
|
5. |
Apparent Slip Flow of Polymer Solutions |
|
Transactions of the Society of Rheology,
Volume 29,
Issue 1,
1985,
Page 67-102
Yoram Cohen,
A. B. Metzner,
Preview
|
PDF (1449KB)
|
|
摘要:
The flow behavior of aqueous and organic polymer solutions in laminar flow was studied experimentally in small‐diameter tubes. The tube diameters ranged from 0.0190 to 0.1097 cm and theL/D(length/diameter) ratios were 20–2700. The experimental flow rates were abnormally higher than the predictions based on viscometric cone‐and‐plate data. This abnormal flow enhancement is termed hereapparent slipand it was quantified by an effective slip velocity. The effective slip velocity was found to increase with the wall shear stress. The contribution of slip, however, to the total flow rate for a given tube diameter decreased with increasing wall stress due to shear thinning. Additionally, for a given wall stress, the contribution of slip increased with decreasing tube diameter. Qualitatively, theapparent slipphenomenon is expected to occur for the flow of elastic high‐molecular‐weight, nondilute polymer solutions in inhomogeneous stress fields.
ISSN:0148-6055
DOI:10.1122/1.549811
出版商:The Society of Rheology
年代:1985
数据来源: AIP
|
6. |
Note: Frictional Effects in Compressional Deformation of Gelatin and Starch Gels and Comparison of Material Response in Simple Shear, Torsion, and Lubricated Uniaxial Compression |
|
Transactions of the Society of Rheology,
Volume 29,
Issue 1,
1985,
Page 103-108
E. B. Bagley,
D. D. Christianson,
W. J. Wolf,
Preview
|
PDF (306KB)
|
|
ISSN:0148-6055
DOI:10.1122/1.549812
出版商:The Society of Rheology
年代:1985
数据来源: AIP
|
7. |
Abstracts of the Australian Society of Rheology, Second National Conference on Rheology |
|
Transactions of the Society of Rheology,
Volume 29,
Issue 1,
1985,
Page 109-116
Preview
|
PDF (458KB)
|
|
ISSN:0148-6055
DOI:10.1122/1.549838
出版商:The Society of Rheology
年代:1985
数据来源: AIP
|