1. |
Physiological cost of work under hot dry climates in Indian industries An analysis |
|
International Journal of Production Research,
Volume 13,
Issue 5,
1975,
Page 429-441
S. P. DUTTA,
T. GANGULY,
Preview
|
PDF (427KB)
|
|
摘要:
The possibility of using pulse rate during work as a measure of the energy coat of that work, in lieu of the more cumbersome gas analysis techniques, has been examined in actual industrial environments for varied work and thermal loads. Three sets of data from some hot dry industries situated in different parts of India were analysed : (a) extreme levels ; (b) moderate levelB ; and (c) comparatively low levels of work and heat loads. Pulse rate (PR) measurements, in conjunction with body surface area (BSA) and corrected effective temperature (CET) were found to be significantly correlated with energy expenditure (EE) at both high and moderate levels (τ= 0-889 and 0-902, respectively); the predictive ability of the corresponding regression coefficients was also high (SE of estimate—± 10%).
ISSN:0020-7543
DOI:10.1080/00207547508943014
出版商:Taylor & Francis Group
年代:1975
数据来源: Taylor
|
2. |
On the selection of mass production systems |
|
International Journal of Production Research,
Volume 13,
Issue 5,
1975,
Page 443-461
KAY WILD,
Preview
|
PDF (592KB)
|
|
摘要:
This paper is concerned with the comparison and selection of systems for the mass production, in particular the assembly, of complex discrete items. A possible procedure is proposed for system selection based upon (a) an examination of the feasibility of using certain basic system types in particular situations, (b) a comparison of feasible alternatives based upon certain quantifiable factors, and finally (c) a study of the non-quantifiable aspects of systems. Basic system types are listed, a detailed procedure is proposed for the quantitative analysis and some relevant non-quantifiable factors are identified.
ISSN:0020-7543
DOI:10.1080/00207547508943015
出版商:Taylor & Francis Group
年代:1975
数据来源: Taylor
|
3. |
Assembly line sequencing for model mix |
|
International Journal of Production Research,
Volume 13,
Issue 5,
1975,
Page 463-477
E. M. DAR-EL,
R. F. COTHER,
Preview
|
PDF (446KB)
|
|
摘要:
This paper describes a model sequencing algorithm for model-mix assembly lines. A new formulation of the sequencing problem is proposed, the objective function of which is to minimize the overall assembly line-length for no operator interference. Lower bounds for the overall line-length are developed.
ISSN:0020-7543
DOI:10.1080/00207547508943016
出版商:Taylor & Francis Group
年代:1975
数据来源: Taylor
|
4. |
An algorithm for scheduling parallel processors |
|
International Journal of Production Research,
Volume 13,
Issue 5,
1975,
Page 479-486
M. K. RAJARAMAN,
Preview
|
PDF (258KB)
|
|
摘要:
This paper deals with optimal scheduling of jobs on identical parallel processors. The paper develops an algorithm for determining the optimal schedule and gives a proof of the algorithm. The criterion used is that of minimizing the total cost for processing all jobs when the jobs are assigned non-decreasing waiting costs which are non-linear. Extension of the algorithm for jobs with due dates is also given. Computational results are given which indicate the effectiveness of the algorithm as compared to complete enumeration.
ISSN:0020-7543
DOI:10.1080/00207547508943017
出版商:Taylor & Francis Group
年代:1975
数据来源: Taylor
|
5. |
Scheduling a multi-product single machine system A new approach |
|
International Journal of Production Research,
Volume 13,
Issue 5,
1975,
Page 487-493
S. K. GOYAL,
Preview
|
PDF (206KB)
|
|
摘要:
In this paper, a method based on a new approach has been given for tackling the scheduling problem usually encountered when a number of products are manufactured on a single machine on a repetitive basis. The method provides a near optimum schedule for multi-product single machine systems, and is eminently suitable for those systems where machine utilization is high. An example has been solved for illustrating the method.
ISSN:0020-7543
DOI:10.1080/00207547508943018
出版商:Taylor & Francis Group
年代:1975
数据来源: Taylor
|
6. |
Optimum production lot size model for a system with deteriorating inventory |
|
International Journal of Production Research,
Volume 13,
Issue 5,
1975,
Page 495-505
RAMB. MISRA,
Preview
|
PDF (314KB)
|
|
摘要:
A production lot size model has been developed for an inventory system with deteriorating items. Both the varying and constant rate of deterioration have been included in the analysis. For the case of a varying rate, it seems impossible to obtain a simple expression for the production lot size, so a numerical method has been suggested. For the constant rate of deterioration case, an approximate expression has been derived for the production lot size. Finally, a numerical example is solved to show the impact of deterioration.
ISSN:0020-7543
DOI:10.1080/00207547508943019
出版商:Taylor & Francis Group
年代:1975
数据来源: Taylor
|
7. |
An EOQ model when production standards are assumed to be normally distributed |
|
International Journal of Production Research,
Volume 13,
Issue 5,
1975,
Page 507-517
A. L. SOYSTER,
E. E. ENSCORE,
Preview
|
PDF (385KB)
|
|
摘要:
In this paper an EOQ model is developed especially for a production environment where the inventory to be controlled is raw material. The fundamental difference between this model and others is that a stochastic demand is placed upon the inventory in terms of the time for an individual to consume one unit of inventory rather than the number of units consumed in some time interval. A shortage cost for inventory is imposed via the idle machine (man) cost. The optimal re-order quantity is determined as a function of the stockout probability and the optimal stockout probability is obtained via a one-dimensional search, over some prescribed set of feasible stockout probabilities.
ISSN:0020-7543
DOI:10.1080/00207547508943020
出版商:Taylor & Francis Group
年代:1975
数据来源: Taylor
|
8. |
Production planning when demand is increasing |
|
International Journal of Production Research,
Volume 13,
Issue 5,
1975,
Page 519-522
N. A. J. HASTINGS,
Preview
|
PDF (108KB)
|
|
摘要:
A Hquare-root formula is derived for determining an optimum production schedule under increasing demand and with simple cost assumptions.
ISSN:0020-7543
DOI:10.1080/00207547508943021
出版商:Taylor & Francis Group
年代:1975
数据来源: Taylor
|
9. |
A stochastic equipment capacity model |
|
International Journal of Production Research,
Volume 13,
Issue 5,
1975,
Page 523-525
DMITRISP. PSOINOS,
Preview
|
PDF (107KB)
|
|
摘要:
This paper presents a model for the determination of the optimal equipment capacity for situations where a stochastic demand of Bervicea can be met by both owned equipment operating on a regular and overtime basis and hired-in equipment from an external source.
ISSN:0020-7543
DOI:10.1080/00207547508943022
出版商:Taylor & Francis Group
年代:1975
数据来源: Taylor
|
10. |
Measurement of Human Resources. By W. T. SINGLETON and P. SPUBGEON. (London : Taylor & Francis Ltd, 1975.) [Pp. 368.] Price £8-50. |
|
International Journal of Production Research,
Volume 13,
Issue 5,
1975,
Page 527-528
R. J. SUKY,
Preview
|
PDF (59KB)
|
|
ISSN:0020-7543
DOI:10.1080/00207547508943025
出版商:Taylor & Francis Group
年代:1975
数据来源: Taylor
|